Difference between revisions of "Network"

From Control Solutions IoTServer Documentation
Jump to navigation Jump to search
Line 1: Line 1:
 
== Network ==
 
== Network ==
[[File:Network settings page 1.jpg|850]]
+
[[File:Network settings page 1.jpg|850px]]
  
 
Each device has two Ethernet ports. These are called "eth0" and "eth1" on the device.They support both ipv4 and ipV6. If an IP address is defined, the device will use those settings for the port. If you leave them blank, it will rely on DHCP.
 
Each device has two Ethernet ports. These are called "eth0" and "eth1" on the device.They support both ipv4 and ipV6. If an IP address is defined, the device will use those settings for the port. If you leave them blank, it will rely on DHCP.

Revision as of 15:52, 3 May 2019

Network

Network settings page 1.jpg

Each device has two Ethernet ports. These are called "eth0" and "eth1" on the device.They support both ipv4 and ipV6. If an IP address is defined, the device will use those settings for the port. If you leave them blank, it will rely on DHCP.

Default Settings

When a device is initially booted, eth0 will default to a static IP address of 10.0.0.101. Eth1 will be set dynamically by your DHCP server on your network.

Interface Default IP
eth0 10.0.0.101
eth1 DHCP/Dynamic